Cannot weld the sealed end absolutely

 to depend on is spatially the contact resistance eliminates the paint, belongs to the extremely precise part, welds spatially one time, the sealed end life has reduces a half possibility.Welds spatially the meaning is when an object which the sealed end acme has not contacted other to be possible to transfer heat has the flame, does not pay attention in the situation is often trading the sealed end, rubs the sealed end, lifts time appearance which the sealed end clamps, therefore must pay attention extremely, carries on the time tight summary which above operates to turn off light the source.

The parameter cannot excessively be high, specially new sealed end

 new sealed end if uses the big parameter from the very beginning, so long as hits a time fire to be able to change and the old sealed end is not equally easy to use, the truth and welds is spatially same.Therefore each only new sealed end as far as possible must move the time below 12MS, the voltage adjusts below 1.20V to start to try to weld, again adjusts the high voltage according to the effect.

The sealed end do not have among the loose

 sealed end to be frequently the insulating compound, the important sealed end loosens again can affect the acme two side sealed ends the contact positions, causes the welding effect not to be very good, therefore suggested intensely, the sealed end will install later to use the sealed end not to be able continuously to use up to only then to take, the midway do not have to disassemble the sealed end frequently.

The sealed end clamps the clamp place to want cleanly clean

 because welds uses is the big electric current, must hit the very big parameter frequently the reason is because the sealed end clamps the clamp sealed end the place dirt to be very many, affected the electric current to flow seriously.Therefore suggested each month wants the clean clean this spot.

Must appear not not good

to the line generally is correctly because does not permit to the line to create, has two main points to the line, one is the line must pass through nearby sealed end bottom end two, two is the time which looked has the error, must press the line in the sealed end bottom end middle position, but looks like time is presses the line behind the sealed end the place.

Rubs the sealed end the method

 sealed end welding unreliable or the time which tapes, first should rubs the sealed end, but adjusts the high parameter, rubs the sealed end time had to use to repair the microsection or the W5 thin sandpaper comes to rub lightly 12 may.

Each sealed end all has the difference, cannot use the similar parameter

 sealed end is extremely frail and the precise product, when exwork has a standard scope, but is dissimilar as a result of the different machine connection effect, the different product surface oxidation degree is dissimilar, the sealed end laying aside time oxidizes the degree not to be dissimilar differently, simultaneously, each sealed end common difference is dissimilar, although all in qualified scope, but as a result of the spot effect and the machine, the connection effect, the face of weld oxidation degree, to the line situation, dynamics which the foot steps on and so on many kinds of factors is related, therefore each sealed end should correspond the parameter hasThe difference, strict says does not have the means to achieve has the completely same welding effect two sealed ends, but so long as the parameter is appropriate, the welding effect all is not big in a scope or the difference.Only then defers to above request to do, and can let the sealed end welding effect be very good achieves the longest service life.